Pinned
Kaleb Reinhart
6,644 posts
Kaleb Reinhart
@t3nable
Engineer of all the things! Hardware, software, machining and fabrication, automotive, RF, EV and HV systems. Founding engineer at Hyper Electric Marine.
Indiana, USA
Joined January 2018
- Whatever it is, it needs a new bearing
- Lets just hope the aluminum harbor freight drop receiver is cool with operating at 91% of rating continuously
- Had to try the pot
00:00
will give $100 to the fastest sub 1 minute speed run of soldering a Pi Pico (by Oct. 3rd) Rules: 1. MUST BE DONE SAFELY! Wash hands, safety glasses, no burning yourself 2. Must play Scary Monsters and Nice Sprites by Skrillex while soldering 3. Must be properly soldered!!! - Printing custom TPU bellows is awesome! This size is $116 per retracted 1 3/8” (1’ extended) on McMaster for rubber. With this technique I can print them any ID, OD, wall thickness, and length I want. also trivial to do shaped other than round.
00:00 - Easiest way to mount a PCB in a 3D print. Make studs that stick thru the holes and melt them down against the board with your least favorite soldering iron
- I fucked up and only ordered two of these fan guards, needed three. So I downloaded the STEP from McMaster and printed it.
- Made an inclinometer that clamps around a motor to accurately set the angle of the grinder wheel attached to it.
00:00
