Skip to main content
Suchen Sie etwas anderes?
Syslog
Enable Syslogd to capture system messages. To send them to another system, enter the IP address of a remote syslog server.
Syslog Out Mode: 3 mode options.
Net: The log information output to a syslog server.
Console: The log information output to console port. (The log from the console is the most detailed, so if need to debug, could run serial port software to read and save the log).
Web: The log information output to local web page.
Remote Server: If choose net mode, users should input a syslog server’s IP Address and run a syslog server program on it.
Enter the “ethernet” or “modem” connection type:
For an ethernet configuration, make sure the IP parameters are compatible with server access according to the concentrator local network configuration. For an ethernet connection, the configuration must be compatible with the concentrator’s local network topology so that it can access the servers. This configuration is done from the “Networks” configuration page (see section 3.2.2.3: “Networks”).
For a modem connection, the modem configuration must be correct before a connection can be set up. This configuration is done from the “Modem” configuration page (see section 3.2.2.4: “Modem”).
The parameters for the servers to be configured are at least the following:
Therefore the following fields need to be configured: “Interface”, “Type”, “Server type”, “Address”, “Port”, “Login” and “Password”.
The other fields can be left at the default values subject to the directories having been properly created beforehand. See section 3.1.2: “Configuration files” for more details.
Wait. The concentrator will reboot using its factory configuration.
