Communication Software for Protection Relays | SIA – SIL – SIU – SIR
The SICom program works with the Windows® 2000/XP, Windows 7 and Windows 10 operating system and can be used to gain access to all of the relays information, to modify the settings and to save events using a graphic
user interface.
Communication Software for RNX2000 | Remote Control Unit (RTU)
LGGE – Logic Gate Graphic Editor
Communication Software for Motor Management System PBM
The PBCom PC software communicates with the Fanox PBM Motor Protection Relay. The software is designed to access PBM relay information, modify the settings, check states and measurements, and analyze and save events and fault reports using a graphic-friendly user interface.
It will allow the user to prepare all the settings and relay configurations without having the relay connected to the PC (offline mode), reducing engineering and commissioning time.
PBCom software uses Modbus protocol, so ports with this protocol are required to establish the communication.
Communication Software for EMM
The NRG2 PC software is used to communicate with Fanox EMM Network Analysers. Software is designed to gain access to EMM relay information, to modify the settings, check states and measurements and to analyse and save network parameters. It is a PC monitoring SCADA using a graphic-friendly user interface.
The main operations that can be carried out using the NRG2 software are as follows:
NRG2 software uses Modbus protocol, so ports with this protocol are required to establish the communication.
