Supported Device Models
- Smart Plug E2 [Type F, With power monitoring) [Model Number: 3RSPE01044BZ]
- Smart Plug Gen1 [Type B, No power monitoring] [Model Number: 3RSP019BZ]
- Smart Plug Gen2 [Type B, With power monitoring] [Model Number: 3RSP02028BZ]
Version 1.01.01 [2025-12-01]
Bug Fixed:
- Optimized cumulative energy storage logic to prevent anomalies caused by extremely low or excessively high power values.
- Enhanced protocol handling to improve overall compatibility with the Hue gateway.
Version 1.00.98 [2025-09-08]
Bug Fixed:
- Modified the Energy Consumption and Power Reporting functions to enhance accuracy and reliability.
Optimization:
- Set “StartupOnOff” default to “PreviousValue” to ensure more consistent device behaviour after reboot or power cycle.
- Set the reporting threshold to 0.001 kWh.
Version 1.00.92 [2024-12-27]
Bug Fixed:
- Fix the issue of abnormal termination during the OTA process
- Fix the issue of abnormal power metering clean failure in the private attribute function
Optimization:
- Optimize the parameters and logic for status detection and reporting after Zigbee network access
- Optimize the Zigbee network entry channel and support full-channel detection
Version 1.00.88 [2024-08-30]
Bug Fixed:
- Fixed the version display issue on the Samsung platform after adding a device.
- Corrected the effective power calibration coefficient.
Optimization:
- Added a fixed reporting time of 10 minutes after the downhill reporting.
- Enhanced online/offline detection logic.
- Adjusted power reporting is triggered when the difference is >1% and >1W.
- Added “clear total power metering” and “countdown” private attribute support (requires compatible gateway, verified HA&ThirdReality Bridge with 3R-Installer App).
- Added “AC_PowerFactor” parameter report.
————————————————————
Firmware Updates since April 2023
Version 1.00.74
-
Fix the LED light status issue
-
Optimize Zigbee signal distance
Version 1.00.71
-
Fix the issue of turning on/off multiple times after the power is restored
-
Optimize the power monitoring report
-
Fix bugs
Version 1.00.65
-
Fix the device model number issue in SmartThings
-
Optimize the power monitoring report
-
Fix the power factor report issue
Version 1.00.59
-
Fix the LED light status issue
-
Optimize the power monitoring report
Version 1.00.53
-
Fix the issue of the startup on/off status setting after the firmware update
-
Fix the LED light status issue
Firmware OTA is available through the Third Reality app over Zigbee (Third Reality smart hub required), Home Assistant ZHA/Zigbee2MQTT (Zigbee dongle required), and Hubitat(hub required).
