Gebrauchtgeräte

Advanced WP7-90-27-300 SN 200445   Temperature up to: 90 °C / 194 °F Heating capacity: 27 kW Cooling capacity: 300 kW Circulating medium: Water up to 90°C Flow rate: max. 230l/min Max. pressure: max. 2,3 bar Motor capacity: 0,75 kW     Voltage: USA Stock location: Single USA Serial Nuber : 200445 Typ : Used Unit   Hydraulic functional equipment ·        Cooling and filling controlled by solenoid valve·        Configurable automatical filling via cooling water or separate connection (ex works cooling water inlet)·        Flow measurement by differential pressure·        Level monitoring by magnetic float switch·        Automatic temperature-dependent system closing (not for 90°C)·        Flow monitoring by recording surface temperature of heating rods and flow·        Bypass between to and from process with reduced cross-section·        Dirt trap in cooling water supply, filling connection and return line of circulating system·        Continuous bypass of heat exchanger by 3-way-motorvalve (WP7-180/200)·        System pressure monitoring by pressure transmitter in extension vessel (WP7-150/180/200)·        Booster pump for filling (WP7-180/200, 150° optional)·        Saftey temp. limiter (STB) in heating and to process line (WP7-200)·        Manometer in to process line at backside of unit·        Medium circuit insulated (WP7-150/180/200)   Functional equipment electrical   ·        Smart Controller (7" touch display)·        Heating control by solid-state-relay·        Control cabinet IP54General equipment ·        Expansion vessel, heater and piping made of stainless steel·        Heating with Incolloy stainless steel tubular heaters·        Dirt trap (medium): EN-GJL-250; GP240GH+N·        Unit ready for connection and  mounted on castors, thereof 2 swivel castors with brakes  Special equipment ·        Special voltage 440-480V +/-5% / 60Hz 3p ·        Pipe connection for filling WK3 with ball valve·        Special setting in the unit: - for manual filling·        Air inlet valve (Art.No.06653) in the manual filling line, after ball valve Overflow valve for WP7 between to and from process up to 150° discharge pressure: * 1,5 bar for units  with flow measunring: the total flow rate of the device will be displayed.  (overflow valve will be mounted before flow measuring)   Professional package: ·        Smart Controller plus·        Prequency converter·        Pressure transducer·        If a fault-current circuit breaker (FI) is installed in the electrical supply line to the TCU, a FI "Type B" must be        used.·        If the rated current of the FI is 30mA only one TCU can be operated at this FI·        Alarm status Alarms and Warnings by potential-free contact on clamp on I/O-board incl. warning for delta T (pre- and return run) and return run temperature (- no charge)·        Special connections for Medium, cooling water and filling