Raspberry pi clone

2 Articles

Trying Out The Allwinner-Based Walnut Pi SBC

January 16, 2026 by 29 Comments

When it comes to the term ‘Raspberry Pi clones’, the most that they really clone is the form factor, as nobody is creating clones of Broadcom VideoCore-based SoCs. At least not if they want to stay safe from Broadcom’s vicious legal team. That said, the Walnut Pi 1B single-board computer (SBC) that [Silly Workshop] recently took a gander at seems to be taking a fairly typical approach to a Raspberry Pi 4 form factor compatible board.

Part of Walnut Pi’s line-up, the Allwinner H616/H168-equipped 1B feels like it takes hints from both the RPi 4B and the Asus Tinkerboard, especially with its nicely colored GPIO pins. There’s also a beefier Walnut Pi 2B with an Allwinner T527 SoC that’s not being reviewed here. Translating the Chinese-language documentation for the board suggests that either the H616 or H618 may be installed, with both featuring a quad-core Cortex-A53, so in the ballpark of the Raspberry Pi 3.

There are also multiple RAM configurations, ranging from 1 GB of DDR3 to 4 GB of LPDDR4, with the 1 GB version being fun to try and run benchmarks like GeekBench on. Ultimately the impression was that it’s just another Allwinner SoC-based board, with a half-hearted ‘custom’ Linux image, no hardware acceleration due to missing (proprietary) Allwinner IP block drivers, etc.

While cheaper than a Raspberry Pi SBC, if you need anything more than the basic Allwinner H61* support and Ethernet/WiFi, there clearly are better options, some of which may even involve repurposing an e-waste Android TV box.

Continue reading “Trying Out The Allwinner-Based Walnut Pi SBC” →

It’s A Pi, But It’s Not Quite A Raspberry Pi

August 17, 2025 by 17 Comments

When is a Raspberry Pi not a Raspberry Pi? Perhaps when it’s a Pi Pico-shaped board with an RP3A0 SoC from a Raspberry Pi Zero 2, made by [jonny12375].

Back in the early days of the Raspberry Pi, there was a offering from the Korean manufacturer Odroid, which wasn’t merely a similar machine with a different SoC, but a full clone in a smaller form factor featuring the same BCM2385 chip as the original. It was electrically and software-wise identically to the real thing, which we suspect didn’t go down very well with the Pi folks in Cambridge. The supply of Broadcom chips dried up, and ever since then the only way to get a real Pi has been from the official source. That’s not quite the end of the unofficial Pi story though, because a few hardy experimenters have made Pi clones like this one using chips desoldered from the real thing.

It’s the fruit of a reverse-engineering project to find the chip’s pinout, and it’s a proof of concept board rather than the intended final target of the work. The process involved painstakingly sanding down each layer of a Zero 2 board to reveal the traces and vias. The current board has a few quirks but it boots, making this an impressive piece of work on all counts. We’re looking forward to seeing whatever the final project will be.

If you’re hungry for more Pi-derived goodness, we’ve also seen one using the part form a Pi 3.