Beschreibung
The Raspberry Pi Debug Probe is a complete debug hardware solution for ARM-based microcontrollers, powered by the RP2040. It features a USB-to-two-wire serial debug bridge and a USB-to-UART bridge, making it easy to debug devices like the Raspberry Pi Pico across a range of host platforms, including PC, Mac, and typical Linux computers.
A Complete Kit for Easy, Plug-and-Play Debugging
The Raspberry Pi Debug Probe is an all-in-one USB-to-debug kit that provides all the necessary hardware and cables for easy, solderless, plug-and-play debugging.
It features a processor serial debug interface (by default the Arm Serial Wire Debug interface, but other interfaces are also supported) and an industry-standard UART interface. Both interfaces use the Raspberry Pi 3-pin debug connector, as detailed in the Raspberry Pi 3-pin Debug Connector Specification.
The Raspberry Pi Debug Probe is a kit comprising the Debug Probe hardware in its own plastic case, along with a USB cable and three types of debug cables, covering the majority of debug use cases. It is designed to make it easy to debug and program the Raspberry Pi Pico and RP2040 with a range of host platforms, including Windows, Mac, and typical Linux computers, especially when there is no GPIO header to connect directly to the Pico's serial UART or SWD port.
While designed for use with Raspberry Pi products, the Debug Probe provides standard UART and CMSIS-DAP interfaces over USB, allowing it to be used to debug any ARM-based microcontroller that provides an SWD port with 3V3 I/O, or even just as a USB-to-UART cable. It works with OpenOCD and other tools that support CMSIS-DAP.
The Debug Probe is based on Raspberry Pi Pico hardware and runs the open-source Raspberry Pi Picoprobe software. The firmware is updated in the same way as Raspberry Pi Pico firmware, making it easy to keep the unit up to date with the latest firmware or to use custom firmware.
Specifications
- Form factor: 22mm × 32mm
- USB-to-two-wire serial debug bridge (Arm Serial Wire Debug supported by default)
- USB-to-UART bridge
- Compatible with the CMSIS-DAP standard
- Works with OpenOCD and other tools supporting CMSIS-DAP
- Follows the Raspberry Pi 3-pin Debug Connector Specification
- Includes a high-quality transparent plastic case
- Includes a USB cable and three debug cables: 3-pin JST connector to 3-pin JST connector cable; 3-pin JST connector to 0.1-inch header (female); 3-pin JST connector to 0.1-inch header (male)
- Nominal I/O voltage: 3.3V
Documentation
, ,
