Capsule Machine Maat 0

Advice Sales price: €30-35,-
Material: Plastic

General about Capsule Machine:
The Capsule Machine is a device that allows you to quickly and easily fill your own capsules.
- Automatic closing and ejection of filled capsules
- Faster and easier to use than other products
- Fills 24 capsules in just minutes!
- Available in three sizes: , and - each size only works with capsules of the same size

Fill your own capsules:
- Create your own mixes with your favorite ingredients
- Use high-quality and fresh ingredients
- Save up to 75%
- Avoid binders or excipients

How to use:
1. Read the green instruction leaflet in the packaging. Place the bottom on the stand, with the wide side up. Place the long part of the capsule in the bottom and the short part in the top (open ends facing out).
2. Place the base in a shallow bowl or dish. Pour powder into the base and then distribute the powder using the distribution card provided.
3. If desired, use the tamper to press the powder and then pour in more powder. Repeat if desired. Wipe the excess powder into the bowl through the open corner. Then lift the bottom of the stand.
4. OPTIONAL IF CAPSULES STUCK WHEN CLOSING: Press the bottom slightly down on the center spring until the capsules protrude approximately 3 millimeters. Hold this with one hand and place the top on the bottom with the other hand.
5. Replace the top. Place the device on a flat surface. Press firmly on both sides of the top until the bottom is fully engaged.
6. The capsules are automatically closed and held in the top.
7. Press evenly and firmly on the top: The capsules are ejected.

Extra: https://m.youtube.com/watch?v=JO37r628KDw

MATERIALS:
The Capsule Machine is made of two types of BPA-free plastic: ABS and Delrin Acetal.
·       ABS plastic meets the requirements for contact with food and drinking water, as established by the Food and Drug Administration, the Federal Health Office, the British Plastics Federation and the Bedarfsgegenständeverordnung, among other national and international regulations. ABS is resistant to chemicals and stress cracking from inorganic salt solutions, alkalis, mineral acids (except strong oxidizing acids) and some mineral, vegetable and animal oils. Petroleum-based oils, solvents and dyes SHOULD NOT BE USED as they may damage the material. Powders with a high eugenol content can potentially damage the plastic. Eugenol is an essential oil found in spices such as cloves, nutmeg, cinnamon and bay leaf.
·       The two springs of the Capsule Machine are made of Delrin Acetal plastic. This material meets Food and Drug Administration regulations for repeated food contact and National Sanitation Foundation regulations for use in drinking water.
·       The Distribution Card provided with all Capsule Machines is made of polypropylene. Of the commercial plastics available on the market today, polypropylene is considered one of the safest. It is FDA approved for food contact, so you will find polypropylene in food containers such as those for yogurt, cream cheese, and butter products.

CLEANING:
Because the materials in the Capsule Machine can melt at temperatures near 82°C (180°F), care should be taken when using in a dishwasher. The heat function of many dishwashers can exceed the maximum temperature. Normally washing with warm soapy water is sufficient. Be careful when removing the springs from the bottom or top of the Capsule Machine. Be sure to gently pry the springs from the tabs that hold them in place. And if you want to replace the springs, first put one side under the tab and then the other side. Some powders can stain any plastic surface, such as Capsule Machine surfaces.