There's open source software that is a lot more powerful than this and does not require the dongle. Save yourself some serious time and get MeerK40t or K40 Whisperer both of which can driver the M2 Nano laser controller perfectly fine.
I just purchased the 40w Laser machine and the software is non-functional and I discovered is was written by your company. Is this LaserDRW software a good substitute for the bad software which is Corel draw 12. The software is in Chinese and not English.
Hi!
I have a JK 3020, but I don't have any guide to use this software. Please, be kind to send me a guideline so I can understand how to use it best.
And why when I use the CorelLASER 2013.02 to cut, for example, I draw a circle to cut, but it cuts an ellipse?
Please help me to understand it.
Thank you so much!
I have a JK 3020, but I don't have any guide to use this software. Please, be kind to send me a guideline so I can understand how to use it best.
And why when I use the CorelLASER 2013.02 to cut, for example, I draw a circle to cut, but it cuts an ellipse?
Please help me to understand it.
Thank you so much!