This is the helper library for The Bee Motion S3.
Examples can be found in the examples directory, these can also be loaded from the examples menu in the Arduino IDE.
This library can be installed through the Arduino library manager or manually from github by following the instructions here.
void begin();
// Set LDO2 on or off
void setLDO2Power(bool on);
// Set neopixel power on or off
void setPixelPower(bool on);
// Set neopixel color
void setPixelColor(uint8_t r, uint8_t g, uint8_t b);
void setPixelColor(uint32_t rgb);
void setPixelColor(green); //green, red, blue, yellow, pink, purple, orange, white, aqua, off
// Set neopixel brightness
void setPixelBrightness(uint8_t brightness);
// Pack r,g,b (0-255) into a 32bit rgb color
static uint32_t color(uint8_t r, uint8_t g, uint8_t b);
// Convert a color wheel angle (0-255) to a 32bit rgb color
static uint32_t colorWheel(uint8_t pos);
// Get the battery voltage in volts
float getBatteryVoltage();
// Get the light sensor in volts (0-3.3)
float getLight();
// Detect if VBUS (USB power) is present
bool getVbusPresent();