What happened?
When resuming a large transfer there is nothing shown on either the sending or receiving side while an existing file is being "checked" (unless debug mode is on). This can take a LONG time. It may seem like the process is hung or something else is going wrong with no status being shown.
What did you expect to happen?
Ideally a status message that a particular file is being checked (or even a progress bar like shown when a file is being hashed initially) should be shown on both sides.
Steps to reproduce
- Initiate a large file transfer (in my case 80GB) without any debug
- Abort the transfer process halfway through
- Re-initiate the transfer of the same data
- Watch as the sending/receiving sides show no status while the existing data is being checked
- Finally see the process continue as normal once the check is finished
croc version
10.3.1
Operating System
Other (please specify in additional context)
OS Version
Applies to all OS/versions
Relevant log output
Additional context
If I get the time I could try to submit a PR, but this may be a simple thing to add since you already show progress bars for several other operations.
What happened?
When resuming a large transfer there is nothing shown on either the sending or receiving side while an existing file is being "checked" (unless debug mode is on). This can take a LONG time. It may seem like the process is hung or something else is going wrong with no status being shown.
What did you expect to happen?
Ideally a status message that a particular file is being checked (or even a progress bar like shown when a file is being hashed initially) should be shown on both sides.
Steps to reproduce
croc version
10.3.1
Operating System
Other (please specify in additional context)
OS Version
Applies to all OS/versions
Relevant log output
Additional context
If I get the time I could try to submit a PR, but this may be a simple thing to add since you already show progress bars for several other operations.