Bucket Mouse's sound amplifier from the MGBC adapted to the stock AGB. This mod replaces the original AGB AMP for better sound rather than add a boost to a dated design.
ampvs.mp4
Big shout out to the Mouse for all he does for the community
NOTE: You are responsible if you f*ck it up. This board requires micro soldering and understanding what you are doing
Remove the following parts
You will need to solder to each of these narrow pins seperatly so I recommend putting kapton tap on the other pins
Install the board, soldering to the points it aligns to
Solder the speaker to the round pads marked - and +
-
Please note that the two thin pads next to [5V] are seperate, do not bridge these
-
If the sound is low or only one channel, you need to a new volume wheel
