When plotting a raw object, I can mark bad channels by either clicking on a channel trace or on a channel label. When I do the same thing with ICs, the behavior is inconsistent in two ways:
- Bad (excluded) ICs turn red instead of gray
- I can only click on an IC trace, but not on an IC label (which tries to open a topomap, but fails if no montage is loaded).
I'd like to make this consistent, but we need a way to graphically trigger a topomap from a selected component. Maybe Shift-Click on the label would work for that?
When plotting a
rawobject, I can mark bad channels by either clicking on a channel trace or on a channel label. When I do the same thing with ICs, the behavior is inconsistent in two ways:I'd like to make this consistent, but we need a way to graphically trigger a topomap from a selected component. Maybe Shift-Click on the label would work for that?