Category
Other
Hardware
Other
Is this bug report about any UI component firmware like InkHUD or Meshtatic UI (MUI)?
Firmware Version
2.7.13.597fa0b
Description
Ive just got a LoRa T3-S3 E-ink and im trying to get it to work with meshtastic
Installing the correct firmware does appear to work at first, but attempting to set a region causes the device to reboot with after a RadioLib err=-707
This has happened on a variety of firmware versions, both beta and alpha.
Attempting to use the non E-Ink version of the firmware however does appear to work seemingly normally.
Region can be set, nodes discovered etc.
Switching back to the e-ink firmware without a wipe does preserve settings, however it then starts bootlooping again, each time with the RadioLib err=-707 message before a reboot.
Relevant log output
Category
Other
Hardware
Other
Is this bug report about any UI component firmware like InkHUD or Meshtatic UI (MUI)?
Firmware Version
2.7.13.597fa0b
Description
Ive just got a LoRa T3-S3 E-ink and im trying to get it to work with meshtastic
Installing the correct firmware does appear to work at first, but attempting to set a region causes the device to reboot with after a RadioLib err=-707
This has happened on a variety of firmware versions, both beta and alpha.
Attempting to use the non E-Ink version of the firmware however does appear to work seemingly normally.
Region can be set, nodes discovered etc.
Switching back to the e-ink firmware without a wipe does preserve settings, however it then starts bootlooping again, each time with the RadioLib err=-707 message before a reboot.
Relevant log output