Category
WiFi
Hardware
T-Deck
Firmware Version
2.5.7
Description
When I updated the firmware (and doing a full erase at the same time) on my Llilygo T-Deck to 2.5.*, the option under the "Power" config called "Select if powered from a low-current source (i.e. solar), to minimize power consumption as much as possible" is turned ON by default. With most other hardware I use (RAK4631, Heltec V3 etc), this is OFF by default. This option being on causes the Wifi to only remain connected for around 10 secs at a time, then it disconnects for 10 secs (unreachable via ping), then reconnects, continually. I think this option should be OFF by default, optionally turned on, as it took me days to work out what was going on.
Relevant log output
No response
Category
WiFi
Hardware
T-Deck
Firmware Version
2.5.7
Description
When I updated the firmware (and doing a full erase at the same time) on my Llilygo T-Deck to 2.5.*, the option under the "Power" config called "Select if powered from a low-current source (i.e. solar), to minimize power consumption as much as possible" is turned ON by default. With most other hardware I use (RAK4631, Heltec V3 etc), this is OFF by default. This option being on causes the Wifi to only remain connected for around 10 secs at a time, then it disconnects for 10 secs (unreachable via ping), then reconnects, continually. I think this option should be OFF by default, optionally turned on, as it took me days to work out what was going on.
Relevant log output
No response