Tiniest Raspberry Pi board, measuring just 42x36mm! CM0IQ board is based on Raspberry Pi/EDATEC CM0 Compute module

• Raspberry Pi CM0 Lite
  • 1GHz quad-core 64-bit Arm Cortex-A53 processor
  • 512MB SDRAM
  • H.264/MPEG-4 video decoding, 1080p@30fps
  • H.264 encoding, 1080p@30fps
  • WiFi with extermal antenna connector
• USB type-C for power and gadget mode
• USB-A
• HDMI type D (micro HDMI)
• DSI 4-lane
• CSI 4-lane
• 40-pin GPIO connector, 1.27mm pitch
• SD-card holder
• 5V solder pads
• M2 x4 standoffs for mounting the board

CM0IQ outline dimentions are 42x36mm. Four mounting points are M2x0.4 threaded standoffs with 2mm max depth. Standoff height is 1mm

IMPORTANT: screwing deeply than 2mm can permanently damage the board

CM0IQ board has 40-pin 1.27mm pitch GPIO connector, using standard Raspberry Pi GPIO pinout

Pin 1 location:

Connector has standard Raspberry Pi 22-pin DSI connector pinout

DSI displays are not automatically detected and configuration to config.txt shall be added.

Example for 5" Raspberry Pi Touch Display 2:

dtoverlay=vc4-kms-dsi-ili9881-5inch

Note: Raspberry Pi Touch Display 2 5V power has to be provided separately. 5V is available on GPIO connector, as well as on solder pads at the corner of the board

Connector has standard Raspberry Pi 22-pin CSI connector pinout. Camera modules are not automatically detected and configuration shall be added, for example (Raspberry Pi Camera Module 3):

dtoverlay=imx708