A - Description

-- not all of the mixer configurations applied through the cleanflight configurator are working after the update to 2.xx firmware

B - Steps To Repeat

BOARD SPRacing F3 Deluxe
-- update cleanflight to firmware 2.xx and configure your receiver settings
In my case I found the BUG by using spektrum receiver on serial 3 rx with taer1234 and 1024 us and I am arming the copter via the Aux1

1. Try the default configuration (QuadX) it should work and motors respond correctly to receiver.

2. Change the mixer configuration to HEX+ and try again. The copter will arm but the motors won't respond to commands anymore despite the throttle level they will always keep the signal to the min_throttle

3. Change again to HEX X. With this configuration the copter will work again and respond to motors.

4. Change to HEX H. This mixer does not work as well

C - Video Links

https://youtu.be/KNWpODkTtTc

D - Forum post links

-- provide links to forum posts if you have discussed this with others --

E - Version Information

Cleanflight: v2.X.X
Configurator: v2.X.X

E - Other information

-- SPRACINGF3 Deluxe
-- config dump + diff
dump_diff_HEX+NOTworking.txt
dump_diff_HEXHNOTworking.txt
dump_diff_HEXX_working.txt
dump_diff_Quad+working.txt
dump_diff_QuadXworking.txt
-- FUNFLY30A with BLHeli 14.9
-- Spektrum DX7 Satellite
-- Skektrum DX7
-- See SPRacing website: http://seriouslypro.com/spracingf3
-- windows 7 64bit