hey,

just flashed the "HyperSerialPico_sk6812Cold.uf2" onto a Raspberry Pi Pico,

a "Reset" Device appeared after the Flash in the Device Manager under "other"

Device itself gets Recognized in HyperHDR v20beta

2023-05-09T13:08:18.388Z [LEDDEVICE_ADALIGHT] Opening UART: COM9 2023-05-09T13:08:18.388Z [LEDDEVICE_ADALIGHT] (ProviderRs232.cpp:216) _rs232Port.open(QIODevice::ReadWrite): COM9, Baud rate [2000000]bps 2023-05-09T13:08:18.390Z [LEDDEVICE_ADALIGHT] (ProviderRs232.cpp:221) portName: COM9 2023-05-09T13:08:18.390Z [LEDDEVICE_ADALIGHT] (ProviderRs232.cpp:222) systemLocation: \\.\COM9 2023-05-09T13:08:18.390Z [LEDDEVICE_ADALIGHT] (ProviderRs232.cpp:223) description: Serielles USB-Ger�t 2023-05-09T13:08:18.390Z [LEDDEVICE_ADALIGHT] (ProviderRs232.cpp:224) manufacturer: Microsoft 2023-05-09T13:08:18.390Z [LEDDEVICE_ADALIGHT] (ProviderRs232.cpp:225) productIdentifier: 0xa 2023-05-09T13:08:18.390Z [LEDDEVICE_ADALIGHT] (ProviderRs232.cpp:226) vendorIdentifier: 0x2e8a 2023-05-09T13:08:18.390Z [LEDDEVICE_ADALIGHT] (ProviderRs232.cpp:227) serialNumber: E66138935F287729 2023-05-09T13:08:18.415Z [LEDDEVICE_ADALIGHT] Detected Rp2040 type board. HyperHDR skips the reset. State: 0, 0 2023-05-09T13:08:18.496Z [LEDDEVICE_ADALIGHT] ESP sent: 'HyperHDR frames: 0 (FPS), receiv.: 0, good: 0, incompl.: 0, mem1: 0, mem2: 206, heap: 124256' 2023-05-09T13:08:18.496Z [LEDDEVICE_ADALIGHT] ESP sent: 'RGBW => Gain: 255/255, red: 160, green: 160, blue: 160' 2023-05-09T13:08:18.496Z [LEDDEVICE_ADALIGHT] DETECTED DEVICE USING HYPERSERIALESP8266/HYPERSERIALESP32 FIRMWARE (Welcome! Awa driver 9.) at 1 msec