Report preparation
What happened?
The new RC-28 external knob auto-snap tuning that rounds the tuned frequency to the nearest 1 kHz doesn't continue from the snapped frequency when the knob is rotated again after the snap occurs. Instead of tuning from the 1 kHz-aligned frequency when it is turned, it starts from the original pre-snapped frequency.
What did you expect?
Tuning starts at the frequency on the flag even after a snap to 1 kHz event has happened.
Steps to reproduce
Enable the Auto-snap to nearest 1 kHz after rotation stops setting in the Icom RC-28 Button Mapping dialog
Set step-size to 100 in the RX Controls dialog box
Tune to a frequency just off by a couple hundred hz from 1 kHz boundary and stop rotation such as stop at 14.250.2
Tuned frequency snaps to 14.250.0 Mhz
Rotate knob clockwise after the snap and the first frequency change is a switch to 14.250.2 Mhz. Stop rotation at 14.250.3 Mhz and it snaps back to 14.250.0
Rotate knob counter clockwise after the snap, which should decrease the frequency to 14.249.9, but it tunes first to 14.250.3, then continues downward as the counter clockwise rotation continues.
aethersdr-20260630-234232.log
aethersdr.log
AetherSDR version
26.6.5
Radio model & firmware
Flex 6600 fw 4.2.20
Operating system
Windows
OS version and hardware
Windows 11 pro 24h2
Report preparation
What happened?
The new RC-28 external knob auto-snap tuning that rounds the tuned frequency to the nearest 1 kHz doesn't continue from the snapped frequency when the knob is rotated again after the snap occurs. Instead of tuning from the 1 kHz-aligned frequency when it is turned, it starts from the original pre-snapped frequency.
What did you expect?
Tuning starts at the frequency on the flag even after a snap to 1 kHz event has happened.
Steps to reproduce
Enable the Auto-snap to nearest 1 kHz after rotation stops setting in the Icom RC-28 Button Mapping dialog
Set step-size to 100 in the RX Controls dialog box
Tune to a frequency just off by a couple hundred hz from 1 kHz boundary and stop rotation such as stop at 14.250.2
Tuned frequency snaps to 14.250.0 Mhz
Rotate knob clockwise after the snap and the first frequency change is a switch to 14.250.2 Mhz. Stop rotation at 14.250.3 Mhz and it snaps back to 14.250.0
Rotate knob counter clockwise after the snap, which should decrease the frequency to 14.249.9, but it tunes first to 14.250.3, then continues downward as the counter clockwise rotation continues.
aethersdr-20260630-234232.log
aethersdr.log
AetherSDR version
26.6.5
Radio model & firmware
Flex 6600 fw 4.2.20
Operating system
Windows
OS version and hardware
Windows 11 pro 24h2