What happened?
If I open AetherSDR and the radio was previously in a CW mode, the decode works fine. However, if I change to a different profile that happens to be CW, the decode stops working. I can only get decode to start working again if I close AetherSDR and reopen (provided I left the radio in a CW mode).
What did you expect?
No response
Steps to reproduce
No response
Radio model & firmware
FLEX-6400
Linux distro & Qt version
MacOS, 0.7.4
What happened?
If I open AetherSDR and the radio was previously in a CW mode, the decode works fine. However, if I change to a different profile that happens to be CW, the decode stops working. I can only get decode to start working again if I close AetherSDR and reopen (provided I left the radio in a CW mode).
What did you expect?
No response
Steps to reproduce
No response
Radio model & firmware
FLEX-6400
Linux distro & Qt version
MacOS, 0.7.4