support-bundle-20260411-213040.zip

After upgrading to 0.8.9.1, when I switch bands, the preferred antenna is not set correctly. About 50% of the time the band change will select the correct antenna; other times, it will momentarily set the correct antenna but then switch to the antenna at the top of the list, When it does this momentary switch, it always goes to Antenna1 at the top of the list, but that is only sometimes... Keeping in mind it was 100% working before the upgrade to 0.8.9.1 from .0.8.8.

So when I go from any of my profiles 10mFT8, 12mFT8, 15mFT8, on down to 80mFT8 sometimes it will select the correct antenna on the AG8x2, but when I hit my 60mFT8 profile, it sets it every time. Then I can start going back up the bands and it will keep the correct antenna selected most of the time. I can not seem to figure out the pattern.

I have set the antenna selection from the Flex AG app, then in AetherSDR went to profile manager and resaved the profile. Same issue. I have set the antenna from the AG app in the AethererSDR GUI, and tried to resave the profile, same issue.

Thank you for all the work you guys are doing on this app.

Scott-W0TTP