Issue overview

Example file UnitarySystem_DXCoilSystemAuto shows incorrect sizing of downstream heating coil. This example file uses 2 unitary systems, one with a cooling coil upstream of the other which has a heating coil. With these systems in the same air loop the original intent was to size the coils with the same capacity. This is partially working, however, the upstream UnitarySystem reports the autosized (independent of the upstream system coil) capacity while the heating coil reports the same as the upstream cooling coil.

 Component Sizing Information, Coil:Cooling:DX:CurveFit:OperatingMode, HEAT PUMP ACDXCOIL 1 OPERATING MODE, Design Size Rated Gross Total Cooling Capacity [W], 24912.98419
 Component Sizing Information, Coil:Cooling:DX:CurveFit:Speed, HEAT PUMP ACDXCOIL 1 SPEED 1 PERFORMANCE, User-Specified Gross Cooling Capacity [W], 24912.98419
Component Sizing Information, AirLoopHVAC:UnitarySystem, DX COOLING COIL, Design Size Nominal Cooling Capacity [W], 24912.98419

Component Sizing Information, AirLoopHVAC:UnitarySystem, HEATPUMP DX COIL 1, Design Size Nominal Heating Capacity [W], 34124.68165
Component Sizing Information, Coil:Heating:DX:SingleSpeed, HEAT PUMP DX HEATING COIL 1, Design Size Gross Rated Heating Capacity [W], 24912.98419

Details

Some additional details for this issue (if relevant):

• Platform (Operating system, version)
• Version of EnergyPlus (if using an intermediate build, include SHA)
• Unmethours link or helpdesk ticket number

Checklist

Add to this list or remove from it as applicable. This is a simple templated set of guidelines.

• Defect file added (list location of defect file here)
• Ticket added to Pivotal for defect (development team task)
• Pull request created (the pull request will have additional tasks related to reviewing changes that fix this defect)