A starter template for Raspberry Pi Pico (RP2040) projects in Rust, designed to simplify development with an Arduino-like structure. This example demonstrates sharing a single I²C bus with multiple devices—specifically, two SSD1306 OLED displays.

This project provides a foundation for embedded Rust development on the Raspberry Pi Pico, including hardware abstraction, an application loop similar to Arduino's setup() and loop(), and convenient features like double-tap reset to bootloader.

• Raspberry Pi Pico (RP2040 microcontroller)
• Two SSD1306 OLED displays (typically 128x64 or 128x32 resolution, I²C interface) (optional)

You can remove oled displays implementation

Connect both OLED displays to the same I²C bus (different addresses required, e.g., 0x3C and 0x3D):

Typical I²C pins used in this project (configurable in src/display.rs, in future configuration will move to src/hardware.rs):

• GP2 → SDA (I²C0)
• GP3 → SCL (I²C0)
• 3.3V → VCC
• GND → GND

Adjust addresses and pins as needed for your displays.

• Rust toolchain: rustup target add thumbv6m-none-eabi
• elf2uf2-rs: cargo install elf2uf2-rs
• Optional (for advanced flashing/debugging): probe-rs or probe-run

1. Clone the repository.
2. Build the project:

cargo build --release

3. To generate a UF2 file and flash (hold BOOTSEL button while connecting USB, or use double-tap reset):

cargo run --release   # If using probe-run

Or manually:

elf2uf2-rs target/thumbv6m-none-eabi/release/rp-pico-oled-rust

Copy the resulting .uf2 file to the mounted RPI-RP2 drive.

repo/
├── build.rs                # Build script for Rust configuration
├── Cargo.toml              # Dependencies and project metadata
├── Embed.toml              # Embedded-specific configuration
├── memory.x                # Linker script for memory layout (flash/RAM placement)
├── README.md               # This file
└── src/
    ├── app.rs              # Application logic (Arduino-like setup/loop)
    ├── display.rs          # Configuration and drivers for two SSD1306 displays (and i2c pins)
    ├── double_tap_reboot.rs # Double-tap reset to bootloader (Pico SDK-inspired)
    ├── hardware.rs         # Hardware initialization (I²C, UART, SPI, etc.)
    └── main.rs             # Entry point (no_std, panic handler, etc.)

• The main application loop is defined in src/app.rs. Modify this file to implement your logic, similar to Arduino's loop().
• Displays are initialized in src/display.rs using the ssd1306 crate and embedded-graphics for drawing.
• Hardware peripherals (e.g., I²C bus) are configured in src/hardware.rs.
• Double-tap the reset button (if enabled) to enter bootloader mode for easy flashing.

Extend this template by adding new peripherals in hardware.rs or additional logic in app.rs.

• Shared I²C bus with multiple SSD1306 devices
• Arduino-style application structure for familiarity
• Double-tap reset to bootloader
• No-std compatible with rp2040-hal

MIT License (or specify your preferred license).

Contributions are welcome. Please open issues or pull requests for improvements.

In future releases code will be refactored, for convenience