The ICP-10111 pressure sensor family is based on MEMS capacitive technology which provides ultra-low noise at the lowest power, enabling industry-leading relative accuracy, sensor throughput, and temperature stability. The pressure sensor can measure pressure differences with an accuracy of ±1 Pa, enabling altitude measurement differentials as small as 8.5 cm, less than the height of a single stair step.
Product Link (https://www.dfrobot.com)
SKU：SEN0516
- High accuracy, low power consumption, temperature stability
- Stable data measurement of temperature, barometric pressure and altitude
- Temperature operating range: -40℃ to 85℃
- Pressure operating range: 30 to 110kPa
Download the library file before use, paste it into the \Arduino\libraries directory, then open the examples folder and run the demo in the folder.
/**
* @fn begin
* @brief Init function
* @details Initialize sensor
* @return uint8_t type, indicate return init status
* @retval 0 Init succeed
* @return -1 Init failed
*/
int8_t begin(void);
/**
* @fn setWorkPattern
* @brief Set work mode
* @param mode Work mode select
* @return None
*/
void setWorkPattern(eWorkPattern_t mode);
/**
* @fn getTemperature
* @brief Get the measured temperature
* @return The temperature that sensor obtained
*/
float getTemperature(void);
/**
* @fn getAirPressure
* @brief Get the air pressure that sensor obtained
* @return Return the air pressure that sensor obtained
*/
float getAirPressure(void);
/**
* @fn getElevation
* @brief Get the elevation calculated according to the measured barometric pressure
* @return Return the calculated elevation
*/
float getElevation(void);| MCU | Work Well | Work Wrong | Untested | Remarks |
|---|---|---|---|---|
| Arduino Uno | √ | |||
| Arduino MEGA2560 | √ | |||
| Arduino Leonardo | √ | |||
| FireBeetle-ESP8266 | √ | |||
| FireBeetle-ESP32 | √ | |||
| FireBeetle-M0 | √ | |||
| Micro:bit | √ |
- 2021/11/05 - Version 1.0.0 released.
Written by TangJie(jie.tang@dfrobot.com), 2021. (Welcome to our website)