Hi!
I just got two new fixtures and I got some problems understanding how to properly program them with the ADJ LINK controller.
The fixtures I got are Clay Paky SharBars. They have six individually controllable RGBW pixels and tilt of the whole bar. In addition to this each of the pixels are made up of LEDs and mirrors that move so I have individual pan control of each of the pixels.
The pan is where I encounter a bit of issues. Normally on a moving head I have like pan/pan fine and tilt/tilt fine control and that works perfect. If I have multiple movers I can fan them out, use the effects generator to have them move synchronously or asynchronously so in my mind I thought it would work basically the same with my SharBars since they are more or less like six separate tiny moving heads. However this is not the case! Any time I use the effects generator, the jog wheels or the pan/tilt control in the upper right corner ONLY the tilt is moving! The pan is not reacting whatsoever. If I use the channel faders I can move the pan mirrors without any issues but if I try making anything like a side-to-side sweeping motion the pan is not reacting at all.
I have tried using the MyDMX 3.0 also and it behaves similarly, except the effects using pan affects mirror 1 but not the remaining 5 of them.
Does anyone have any advice on what this could be or how I should go about programming such a fixture? Thanks a lot in advance guys! (DMX chart attached for reference if that helps)
